Choosing the right shape, size and style for a spa has never been easier. Bradford can custom design and manufacture commercial and residential spas to suit all applications. We work closely with architects, engineers, designers, contractors, and owners to develop your design.
Using the pre-engineered Bradford Spa, is a smart investment not only for the owner, but also for the contractor. The owner gets the low-maintenance, long lifecycle, easy-to-clean, hygienic spa to last for all time. And the contractor gets a package that is easy to install, thus saving time and money in the process.
The spa shell arrives pre-plumbed with labelled stub out points, insulated and sitting upon a support frame. Simply place the spa on a suitable support pad which may be prepared for various height elevations of the spa above the finished floor, totally recessed into the floor, or on-grade. Then, position the Brad-Pack equipment skid in the mechanical room.
The plumber will have run (between the spa and mechanical room) the proper number and size of pipes for the spa that was ordered. Now, simply connect those pipes to the spa and Brad-Pack stubs. Draining the spa is accomplished by pumping the water and discharging to a suitable waste via a valve on the discharge side of the filter pump. Fresh water fill is usually achieved with a spout/spigot with an air gap over the spa.
The electrician will need to run power to the disconnects on the Brad-Pack and bond the entire system, including the spa and handrail. The jets are pneumatically activated and controlled by an electronic timer. The vinyl air tube for this switch, the bonding wire, and any spa light wires will need to be run in a conduit.
We want your experience to be a good one. We have built a world-class spa and spent considerable time in the design and engineering so that your job will be easier.